The HDi Ford Ranger/Mazda BT50 GT2 Completed Whole Silicone Hose Kit (Silicone Nomex oil and heat-resistant layer) is specifically designed to replace the Chemical polished factory cold and hot pipes, enhancing airflow potential for improved performance and reduced fuel consumption. Installation of this kit is straightforward and can be accomplished with basic workshop tools. Typically, the process takes less than 30 minutes, making it a quick and easy upgrade for your vehicle.
HDi Ford PX Ranger/Mazda Bt50 3.2l Completed Whole Silicon Hose Kit
The HDi Ford Ranger/Mazda Bt50 GT2 benefit as below:
? Silicone nomex Oil and heat resistant layer
? Improved low end throttle response (refer dyno)
? Minimal pressure drop despite large intercooler sizing (thanks to HDi GT2 technology)
? Increased torque range at low end (refer dyno)
? Reduction of both inlet temperatures
? less engine running temperatures
? Increased performance
? Better reliability and consistency
? Increase power throughout entire RPM range (not only focusing on the PEAK)
? Improve fuel efficiency*
? Best value for money
? Performance guaranteed!
The kit comes with HDi reinforced Silicon hose to replace the Chemical polished Rubber hose which prompt to expand and split.
Full stainless steel screws and brackets the best durability against water and salt corrosion.
The special design allowing enough area for aftermarket 4wd winch to be installed
It also allows good air flow to the radiator!
*The reduced inlet restriction and inlet temperature provides higher density of oxygen for better combustion with the same amount of fuel. Hence, increase mileage!
